On the back of the cover, we then see why it sticks a bit tighter: thermal pads, These usually stick to the lid. If not, we take a soft spatula and lift it off the PCB, then place it in the appropriate place on the lid. This then goes into a separate small plastic bag. If you want to protect the pads: Wrap the lid once with household or aluminum foil.
- 1 - Tools, Tools, Tools
- 2 - Tape Out
- 3 - Lift off
- 4 - Back to bag
- 5 - Interim result
- 6 - 4x Torx T5
- 7 - 4x Phillips PH
- 8 - Removing the cover (1)
- 9 - Removing the cover (2)
- 10 - Half open or half closed?
- 11 - Removing the cables (1)
- 12 - Removing the cables (2)
- 13 - Removing the cables (3)
- 14 - Torx T8
- 15 - Slot-Panel 6x Torx T8
- 16 - Slot Panel replacement
- 17 - Free Willy!
- 18 - Saving the pads
- 19 - Cleaning!
- 20 - 3D Scan
59 Antworten
Kommentar
Lade neue Kommentare
Mitglied
Urgestein
Urgestein
Veteran
Urgestein
Veteran
Urgestein
Veteran
1
1
Veteran
Veteran
Neuling
Mitglied
Veteran
Veteran
Alle Kommentare lesen unter igor´sLAB Community →