Assembly
As with the last printers, Bambu Lab offers written instructions as well as a video to guide you through the assembly process.
Of course, I won’t miss the opportunity to show you the process myself.
So let’s put all the packaging material safely back in the delivery box and make some space.
First we take the so-called portal.
The four screws marked in red on the underside need to be removed.
The base can then be pushed through as a whole at an angle and positioned in the right place.
Once the various transport brackets and cable ties have been removed, we turn our attention to the screw holes hidden under a cover. Using the appropriate bag of screws and the green markings, the two large components are securely connected to each other at the front and rear.
Once the cover is back on, the printer should ideally be hung over an edge for the next step, as shown here.
This allows easy access to the connections on the underside, into which the bundle of Z-axis cables must be plugged.
Once the USB-C and the connector for the X motor and camera are firmly connected, the plastic holder can be screwed in place.
The cable for the Z motors is also plugged in, but routed along the side in a separate channel.
We then position the A1 correctly again, remove the protective film and I have already placed the printing surface.
The well-known “purge wiper”, better known as the “poop thrower”, still has to be attached to the side of the X-axis. More on this later.
18 Antworten
Kommentar
Lade neue Kommentare
Urgestein
Veteran
Mitglied
Mitglied
Urgestein
Veteran
Moderator
Moderator
Urgestein
Veteran
Urgestein
Veteran
Mitglied
Veteran
Mitglied
Moderator
Mitglied
Veteran
Alle Kommentare lesen unter igor´sLAB Community →