Internal structure
If you turn the screw on the underside and move the two sliders to the center, the entire lower part of the housing can be removed to the side.
A surprisingly large fan is revealed, which is supplied directly with fresh air via the honeycomb pattern.
Two screws later, we are no closer to our goal, as a metal plate blocks the way. However, the opening above the RAM probably also ensures some air circulation inside.
A further 8 screws have to be removed from all around, then the middle plate can be taken out with a little effort. However, I can’t see any way of not pulling out the two antenna cables of the WLAN card at the same time as here. They are located under the SSD and the cables are quite short.
But once again, it’s commendable that the two available M.2 slots are connected to the metal plate via a thermal pad. This increases the cooling capacity immensely. Incidentally, the SSD is a Samsung MZVL21T0HDLU-00BT7. The DDR5 RAM is purchased from SK hynix, the exact model is HMCG78AGBSA095N. The aforementioned WLAN card is a soldered Intel AX211 with support for WiFi 6E and Bluetooth 5.3. The Ethernet controller also comes from Intel, an I226-V with 2.5G bandwidth.
4 Antworten
Kommentar
Lade neue Kommentare
Urgestein
Urgestein
Veteran
Urgestein
Alle Kommentare lesen unter igor´sLAB Community →