Jein. Sobald du auch DP überträgst, ist die schnellste Variante von USB 3 ( USB3.2 Gen2x2) auf dem USB-C Stecker nicht mehr möglich, wenn du DP-1.4 übertragen willst bleiben nur die langsamen USB-2.0 Leitungen für USB übrig. Das würde ich schon als Einschränkung bezeichnen. Wenn sie sich auch in vielen Anwendungsfällen nicht bemerkbar macht.
Das stimmt laut Spec so aber nicht ganz:
"On 22 September 2014, VESA published the
DisplayPort Alternate Mode on USB Type-C Connector Standard, a specification on how to send DisplayPort signals over the newly released USB-C connector. One, two or all four of the differential pairs that USB uses for the SuperSpeed bus can be configured dynamically to be used for DisplayPort lanes. In the first two cases, the connector still can carry a full SuperSpeed signal; in the latter case, at least a non-SuperSpeed signal is available."
Also nur, wenn alle 4 DP Lanes nötig sind, ist nur noch USB2 möglich. Bei DP 1.4 (hat nichts mit der Lane Anzahl zu tun, sondern mit dem Takt des Signals) hast du pro Lane 8,1 GBit/sec. Bei 2 Lanes also 16,2 GBit/sec, was bei FullHD Auflösung bis über 200Hz geht, bei QHD bist du da auch noch bei grob 150Hz. Wie gesagt, mit gleichzeitig SuperSpeed, also USB 3.2 (10GBit).
Dass 3.2 2x2 (20GBit) nicht funktioniert, das stimmt allerdings, daher hatte ich ja geschrieben "USB nutzt nicht grundsätzlich alle Leitungen des USB-C Anschlusses". Nicht grundsätzlich, da eben die langsameren Standards nicht alle Leitungen nutzen und daher für DP die halbe Leitungszahl übrig bleibt.
Also ja, es gibt Einschränkungen, aber für die meisten sind die nicht so dramatisch.